Lesson 68 · Connecting your mecano to a program

Mecano basics · 5 min · See the playlist on YouTube ↗

✓ You already watched this lesson

Your progress is saved only in this browser, in a cookie of our own. It is never sent anywhere.

The lesson that closes the area: the mecano connects like any device and your program controls it through the pins. A block talks to pin thirteen and the LED you placed on thirteen lights up.

🎯 The challenge of this lesson

Change the LED pin on the mecano, not in the program, connect it again and read the report you get; then fix it and check that it no longer appears.

Practise in the app

Stuck on this lesson?

Write your question and another student — or the teacher — will answer. Your email is never published: it is only used to let you know when someone replies.

Before being published, every message goes through an automatic filter that rejects bad language and any attempt to intimidate another person.

  • Loading the questions…